Prior Lake, Minnesota 55372 Phone: (952) 440-8778 or FAX (952) 440-8776
BACK HOMEPAGE VEHICLES
FOR SALE E-MAIL
JOHN 
Jeep Body Step
After trying to use the current step available on the market, (the red one
in the photo above), on a project jeep; we discovered it only resembled
a step. Nothing about it is correct and the fit was horrible. We have invested
hundreds of hours to develop our own tooling so we could make an accurate
part for our customers. Our steps are available in either the GPW or Willy's
design and are within a few thousandths in tolerance. USA-made in Minnesota!
It may be priced a bit more than the imposter, but you actually get something
you can use. Satisfaction guaranteed! Willy's design fits MB, CJ2A, CJ3A,
CJ3B and M38.
$40.00 each, left and right available.
WWII Jeep Toolbox Repair Panel
You asked and we responded. Now in stock, left and right sides. Don't settle
for inferior quality parts that don't fit right.
Get ours made in Minnesota. Exact fit and equal to the OEM. We still offer
the full wheel well also!
$75.00
Premium L-Head Engine Head Gasket
We are nof offering a superior quality, all copper head gasket. No more
re-torquing, no more leaking.
$38.00
Taillight Doors
We have a variety of manufacturers. Guide, Industrial lamp, CB etc.
All NOS and ready to go. Excellent condition.
$12.00 each
Jeep Rear Main Seals
Fits all 4-cylinder engines.
$29.50
Jeep Overhaul Set
Premium overhaul set for all 4 cylinder L-head engines.
Copper head gasket and our new rear main seal set included.
USA Made.
Kit price: $92.50
Shock Bushings
NOS shock bushings for all WWII through late CJ5's applications.
$2.00 each
Jeep and Dodge Head Studs
MWM just had the long studs made here in the USA!
Now in stock and ready for your engine rebuild.
Long Stud - $4.75 each
Short Stud - $3.00 each
Nut - $2.00 each
Upper Generator Adjuster Bolt
New MWM product.
Fits ALL 4-cylinder Jeep engines from 1942-1968.
$5.50 each
WWII Headlamps
We stock two types of bulbs for Jeep and Dodge headlamps --
original-looking Seelite or current replacement units.
Available in 6 or 12V for both.
Seelite - $42.00 each
Current Replacement - $20.00 each
Jeep Radiator Hoses
Tired of poor quality hoses that crack? We were too. We have worked with
a manufacturer in the USA
to produce these hoses for you. The lower hose for the M38, MB, GPW and
the CJ series
is custom-made from the newest rubber and it also has the wire reinforcement
inside!
Exact fit and quality-tested.We also stock the correct hose clamps.
M38A1 Upper: $18.00
M38A1 Lower: $22.00
M38 Upper: $14.00
M38 Lower: $22.00
Bypass Hose: $9.75
Jeep Master Cylinder Cover Plates
Tired of paying the increasing prices on the import parts?
Now you can purchase a higher quality, USA-made part from us for less money.
Available for either the WWII Jeep or the M38 and A1. Also fits the CJ series
Jeeps!
$14.00 each
MB/GPW Radio Suppression Filter
Packaged in Studebaker boxes.
Part #669783, Tobe SC 33M-1
$9.50
Jeep Clutch Parts
All Jeep projects usually require these often-worn parts.
Now you can easily repair your sloppy pedals and get your clutch to adjust
properly.
These fit most Jeeps from 1942-1967.
A495 Pedal Shaft - $32.00
Bracket with Bearing - $40.00
Rod Link - $8.00
Cable & Yoke - $23.00
Cable Boot - $17.50
Cable Boot Adapter - $25.00
Z-Tube - $29.00
Z-Tube Seal Kit - $9.00
Ball Stud - $2.75 each
WWII Fuel Gauge
We just found a stash of these perfect fuel gauges.
Correct for any WWII restoration. We took this one out of the box to take
the photo.
$80.00 each.
WWII Jeep/Dodge Switches
Finally available, a high quality set of switches for the WWII vehicles.
Master light, panel and blackout drive all come with the correct metal knob.
Circuit breaker included with the master switch.
We also have some NOS ones left for those who prefer them.
Master Switch - $70.00
Panel and BO Switch - $28.00 each.
NOS Switches - CALL
Push Pull Light Switches
We have found a quantity of surplus push pull light switches for your WWII
vehicle.
These include the circuit breaker too!
$95.00
WWII Antena Mast Base
Finally available, a totally accurate reproduction of the MP48 mast base.
You can't tell this from NOS! Made from heavy brass just like the original.
Now combine our antenna set with the base to completer your restoration.
MP48 - $210.00
Antenna set - $80.00
WWII Antenna Bag
NOS BG56-A bags for the WWII five mast sections. Nice Accessory!
$45.00
NOS WWII Antenna Tie Down
Can be used for vehicle or ground mount antennas.
$22.00
Ford GP Series II Hood Block
Never before available. Correct color, height and detail.
Finish your restoration off nicely with these blocks.
$38.00/pair.
NOS Trailer Socket Assembly
We found a batch of these, complete, as shown.
These parts are available separately also. Call for individual pricing.
$70.00
RETURN TO TOP